Denso BHT-7000 User Manual

Page 71

Chapter 2. Getting Started the BHT-7000 and System Mode

[4.5-2]

Setting the communications parameters for the direct-connect
interface

Selecting "2:CONNECTOR" on the SET COMMUNI-
CATION menu calls up the screen shown at left.

1 PARAMETER:

Switches to the commu-
nications parameters set-
ting screen.

2 PROTOCOL:

Switches to the commu-
nications protocol screen.

Select a desired screen by using the numerical
keys or

* and

* keys, and then press the

ENT key.

To return to the SET COMMUNICATION menu,
press the C key.

(1) Communications parameters setting screen

Selecting "1:PARAMETER" on the SET CONNEC-
TOR screen calls up the screen shown at left.

Highlighted is the current setting.

1 TRANSMIT SPEED:

Sets the transmission
speed.

2 PARITY BIT:

Sets the vertical parity:
none, odd, or even.

3 DATA:

Sets the character length.

4 STOP:

Sets the stop bit length.

Select a desired item by using the numerical keys
or

* and

* keys. Then select a desired set-

ting by using the

* and

* keys.

To return to the SET CONNECTOR screen, press
the C key.

If the BHT-Ir protocol has been selected, the
parity bit, character length, and stop bit length
settings will be ignored.

SET CONNECTOR

1:PARAMETER

2:PROTOCOL

SET PARAMETER
< CONNECTOR >

1:TRANSMIT SPEED:

300 600 1200 2400
4800 9600

19200

38400 57600 115200
2:PARITY BIT :

O E

3:DATA:7

4:STOP:

NOTE

* For BHT-7000s having a 26-key pad, use F5 , F6 , F7 and F8 keys instead of

, and

keys, respectively