5] setting the communications environments – Denso BHT-7000 User Manual
Page 68
52
[4.5]
Setting the communications environments
After the BHT-7000 is initialized, the interface port and communications parameters
are set as listed in the default table below. Do not access them unless necessary.
Listed below are the default communications parameters for the direct-connect inter-
face.
Interface port
Communications protocol
Communications parameters
for the optical interface port
TRANSMIT SPEED
9600 bps
PROTOCOL
(Protocol options)
Optical (Optical interface port)
BHT-protocol
Defaults
SERIAL No.:
ON (Adds serial numbers
to data blocks.)
H. PARITY:
ON (Adds a horizontal
parity.)
LINKUP TIME:
30 seconds
FIELD SPACE:
Ignore
Defaults
Communications parameters for
the direct-connect interface port
TRANSMIT SPEED
19200 bps
PARITY BIT
None
(Vertical parity)
DATA BIT
8 bits
(Character length)
STOP BIT
1 bit
PROTOCOL
(Protocol options)
SERIAL No.:
ON (Adds serial numbers
to data blocks.)
H. PARITY:
ON (Adds a horizontal
parity.)
LINKUP TIME:
30 seconds
FIELD SPACE:
Ignore