Denso BHT-7000 User Manual

Page 70

(1)

Communications parameters setting screen

Selecting "1:PARAMETER" on the SET OPTICAL
screen calls up the screen shown at left.

Highlighted is the current setting.

Select the desired transmission speed by using
the numerical keys or

* and

* keys, and

then press the ENT key.

To return to the SET OPTICAL screen, press the C
key.

(2)

Communications protocol option screen

Selecting "2: PROTOCOL" on the SET OPTICAL
screen calls up the screen shown at left.

Highlighted is the current setting.

1 SERIAL No.:

Selects whether or not the
system will add serial num-
bers to data blocks.

2 H. PARITY:

Selects whether or not the
system will add a horizontal
parity.

3 LINKUP TIME:

Selects the timeout length (in
seconds) to be applied when
a link is to be established.

4 FIELD SPACE:

Selects whether space codes

in the tail of a data field will
be ignored or handled as data.

Select a desired item by using the numerical keys
or

* and

* keys. Then select a desired set-

ting by using the

* and

* keys.

To return to the SET OPTICAL screen, press the C
key.

If the BHT-Ir protocol has been selected, the
serial number and horizontal parity settings
will be ignored.

NOTE

SET PARAMETER
< OPTICAL >

1:TRANSMIT SPEED:

2400

9600

19200

38400 57600 115200

SET PROTOCOL
< OPTICAL >

1:SERIAL No. :

OFF

2:H.PARITY :

OFF

3:LINKUP TIME:
None

60 90 120

4:FIELD SPACE:

Ignore

Data

* For BHT-7000s having a 26-key pad, use F5 , F6 , F7 and F8 keys instead of

, and

keys, respectively