Kanguru 5HD-SATA - Manual (Page 33)

33
8.9 Select Source
The Select Source option allows you to change which port is set as the Source port. This feature
allows you to continue duplicating in the rare situation where the original Source port is no longer
functioning correctly.
Warning! Connecting a Master hard drive to a non-Source port could result in data loss. We highly
recommend not changing the Source location unless the original Source port is no longer responsive.
Tap the ‘RUN’ button to change the Source port location. The green LED indicator will light up next
to the port currently selected as the Source.
8.10 HPA Check
The Host Protected Area (HPA), sometimes referred to as the Hidden Protected Area, is a partition
on the hard drive that is not normally visible to an operating system. Tap the ‘RUN’ button to change
this option’s setting.
• [ ] – HPA Check is disabled (default). The system will not check for HPA partitions.
• [ ٭ ] – HPA Check is enabled. When HPA CHECK is enabled the duplicator will support Host
Protection Areas. When you duplicate a Master HDD that contains HPA, the system will detect
the HPA partition, unlock it, copy the area and then re-lock the area once duplication is complete.
Note: When you view Device Info (see section ) if the drive info displays an ‘H’ in the upper right
corner then the hard disk contains a hidden Host Protected Area.
8.11 No Capacity Check
The duplicator has a built in capacity check function which will check the capacity of the Master
hard drive and the Target hard drive(s) during Full or Brief copy processes and determine whether the
drives’ capacities are the same.
Tap the ‘RUN’ button to change this option’s setting.
• [ ] – No Capacity Check is disabled (default). When a Full or Brief copy process is executed
the system will check the capacity between the Master and Target hard drive(s) to determine
whether the capacity is the same. If the capacity is different the copy process will be cancelled.
• [ ٭ ] – No Capacity Check is enabled. When a Full or Brief copy process is executed the system
will not check the capacity between the Master and Target hard drive(s) and start the copy
process as normal.
Select Source / HPA Check / No Capacity Check