Load – Kanguru 5HD-SATA User Manual

Page 24

6.4 Load

LOAD allows you to store an image of a hard drive to a Storage Center.

A Storage Center is a hard drive that has been formatted to store hard drive images. The Storage

Center allows you to quickly and conveniently access common duplication projects. For information

To load an image of a hard drive to a Storage Center:

1. From the Main menu tap the ‘SET’ button to navigate to LOAD.

2. Connect your Storage Center to the duplicator’s Source port.

3. Connect the Master hard drive to any available Target port.

4. Tap the ‘RUN’ button to begin the load process.

Note: If the screen displays the message “DEVICE NOT FORMATTED” it means that the hard

drive connected to the Source port has not been formatted as a Storage Center. For information

5. The duplicator will ask you to input a file name for the image. Enter a file name:

a) The file name consists of three digits. The digit furthest to the right will be blinking, indicating

that it is currently selected. Tap the ‘RUN’ button to increase the value by one.

b) Tap the ‘SET’ button to select the next digit to the left. Tap the ‘RUN’ button to increase the

digit by one. Repeat this step as necessary.

6. When you have completed naming the image file, hold the ‘RUN’ button and the load process

will begin.

Note: If the image file name you enter already contains an image file previously loaded on the

Storage Center, the system will ask you to confirm overwriting the previously saved file. Tap

the ‘RUN’ button to confirm or tap the ‘SET’ button to cancel.

Size of Source data

IMG file number

Percentage completed

Amount of data loaded

Data transfer rate

7. When the load process has completed you can remove the Master HDD.

Load

This manual is related to the following products: