Kanguru 5HD-SATA - Manual (Page 27)

27
7.4 Button Sound
The BTN. SOUND option allows you to enable or disable the audible tone that sounds when you tap
or hold a button. Tap the ‘RUN’ button to change this option’s setting.
• [ ٭ ] – Button sounds are enabled (default). Tapping a button will be accompanied by a short
tone. Holding a button will be accompanied by a long tone followed immediately by a higher
pitched tone.
• [ ] – Button sounds are disabled. No audible tones will sound when you tap or hold a button.
7.5 Show EXE Time
The SHOW EXE TIME option allows you to enable or disable whether the total execution time for
an operation is displayed on the LCD screen. The total execution time will be displayed after an
operation has completed. Tap the ‘RUN’ button to change this option’s setting.
• [ ] – Disabled (default). The total execution time is not displayed.
• [ ٭ ] – Enabled. The total execution time is displayed.
7.6 Select Image File
SEL IMG FILE is used for selecting an image file that has been saved to a Storage Center.
To select an image file:
1. From the SETUP menu, tap the ‘SET’ button to navigate to the SEL IMG FILE option.
2. Tap the ‘RUN’ button. The digit furthest to the right will be blinking, indicating that it is currently
selected. Tap the ‘RUN’ button to increase the digit by one.
3. Tap the ‘SET’ button to select the next digit to the left. Tap the ‘RUN’ button to increase the
digit by one. Repeat this step as necessary.
4. When you have completed selecting an image file, hold the ‘RUN’ button to confirm your
selection.
Button Sound / Show EXE Time / Select Image File