Kanguru Mobile Clone 1HD Duplicator - Manual (Page 16)

16
3. Tap the ‘RUN’ button. The duplicator will initialize the disks and then ask you to input a name
for the image file.
Please Input
>[000] SEL IMG FILE
a) The file name consists of three digits. The digit furthest to the right will be blinking, indicating
that it is currently selected. Tap the ‘RUN’ button to increase the digit by one.
b) Tap the ‘SET’ button to select the next digit to the left. Tap the ‘RUN’ button to increase the
digit by one. Repeat this step as necessary.
Note: If your duplicator displays the error message, “TARGET NOT FORMATTED” then
the hard drive connected to the “SOURCE” port has not been formatted as a Storage Center
yet (see section 5.2.1 Formatting a hard drive as a Storage Center on page 15).
4. When you have completed naming the image file, hold the ‘RUN’ button and the duplicator will
begin loading an image of your Master HDD to the Storage Center. Note: If the image file name
you enter already contains an image file previously loaded on the Storage Center, the system
will overwrite the previously saved file.
[LOAD ]001 15.94G
33.44%
Size of Source data
IMG file name
Percentage completed
5. When the load process has completed you can remove the Master HDD from the side labeled
“TARGET”.
5.2.3 Duplicating an image file stored on a Storage Center
Now that you have loaded an image file on the Storage Center:
1. From the Main menu, hold the ‘SET’ button to enter the SETUP menu.
2. From the Setup menu, tap the ‘SET’ button to navigate to the SELECT IMAGE FILE option.
SETUP
>[001] SEL IMG FILE
In the example above, file number 001 is currently selected.
(Continued on next page)
Duplicating From a Storage Center