Kanguru Mobile Clone 1HD Duplicator - Manual (Page 14)

14
5. DUPLICATION
The KanguruClone HDD Duplicator can operate in either one of two duplication methods:
• With a Master HDD as the source
• With a Storage Center as the source
Both methods are described in the following sections.
5.1 Duplicating From a Master HDD
Using a Master HDD as the Source is the simplest and most convenient way to perform the duplication
process.
IMPORTANT! Connect your Master HDD on the side labeled “SOURCE”. Connect the Target hard
drives on the side labeled “TARGET”. Connect all drives before you execute an operation.
To execute the duplication of a Master HDD:
1. From the Main menu, tap the ‘SET’ button to navigate to the desired copy mode. For more
information on the different available copy modes see chapter 3. Duplication Modes on page
12.
The screen will display the following:
[BRIEF ] COPY
2. Once you have selected the copy mode, tap the ‘RUN’ button to execute it. The duplication
process begins as the system initializes the connected disks.
[BRIEF ] COPY
POWER ON...
3. Once all connected disks have been detected and initialized, the duplication process begins.
During duplication the screen will display the following information:
[BRIEF ] COPY
30.44%
WARNING! Do not remove any drives while duplication is in progress. Wait for duplication to finish
before removing a drive. If you wish to interrupt the current process, tap the ‘RUN’ or ‘SET’ button
at any time.
4. Once the copy process is completed the screen will either provide you with a “Success” message
or, if for any reason a drive was not duplicated successfully, an error message. Tap the ‘SET’
button to view the total duplication time.
Duplication / Duplicating From a Master HDD