Infloor Infloorboard User Manual
Page 16
www.Infloor.com
16
INST
ALLA
TION
EQUIPMENT REQUIRED FOR INSTALLATION OVER WOODEN SUBFLOOR:
The following is necessary for the installation of Infloorboard™:
•Table or circular saw. A carbide blade is recommended.
•Electric or cordless drill gun with No. 2 Phillips bit (if you are screwing
down boards) and 5/8” drill bit for supply and return bury points
•Sheathing type pneumatic stapler (if you are cross stapling boards)
•Rubber or hard hide mallet
•Chalk line, marking pencils and square
•Vacuum cleaner to clean grooves prior to installation
•6” pieces of 3/8” PEX for alignment of grooves
•Tubing uncoiler is recommended for installing tubing
INSTALLERS NOTE: CUTTING INFLOORBOARD™
Infloorboard™ cuts easily with a quality carbide circular saw blade. Pieces fre-
quently must be cut to provide an accurate fit for each room. It is important
that they be cut squarely to keep the alignment of grooves accurate in the
installation. If you are cutting a large number of boards for a complicated
space, number them and make a map so you remember where they go.