Infloor Infloorboard - Manual (Page 13)

13
INST
ALLA
TION
Infloorboard™ Application & Installation Manual
HOW TO ALIGN THE GROOVES CORRECTLY:
The easiest way to assure the grooves for the pipe are correctly aligned between
boards is to cut 6” pieces of 3/8” ASTM F-876 PEX and use them as alignment
tools. To do this, get the boards close to the desired alignment and press a piece
of tubing in each groove, lapping 3” into the groove of each board, as shown
below. After the board is attached, these should be removed.
ATTACHING INFLOORBOARD™ TO A SUBFLOOR:
GLUING PATTERNS:
Each Infloorboard™ should be glued to a wooden subfloor using construction
adhesive type glue at a minimum 1/8” bead in the gluing pattern below. Every
board should be glued .
Tips For Gluing
The glue may be
applied to the under-
side of the board or
to the floor. Avoid
getting glue in the
groove or where it
may come in contact
with the tubing. Many
glues can damage
PEX tubing.
GLUING PATTERN FOR
INFLOORBOARD™ BOARDS