Adding terminals, Terminal setup, Terminal check-in – Datalogic Scanning PDA User Manual
Page 49: Terminal setup terminal check-in
Terminals
User’s Manual
37
Adding Terminals
Terminal Setup
Before a terminal can be added to FMU for the first time, the terminal must
be set up to recognize FMU. See
“Enabling a Terminal for FMU with Direct
and
“Enabling Terminals for RF Connectivity” on
for detailed information. Once you have enabled a terminal for FMU,
you will not need to perform this step again.
To add a terminal to FMU
1. Select the group to which you want to add the terminal.
2. On the
File
menu, click
Add > Terminal
.
Figure 15. Adding a Terminal
Terminal Check-in
After a terminal has been enabled for FMU, it communicates with the FMU
Server upon reboot, when placed in a dock, or when requested by the server.
The server uses the defined group settings to update the terminal at the next
specified update. See
“Updating Terminals” on page 51
Serial Number Enter the serial number for device
1
.
1. See the PRG for your terminal for instructions on finding the serial number.
IP Address
Enter the IP Address of the terminal.
Assigned
Group
Displays the group to which the terminal will be attached.