Harken 2700 Traveler User Manual
Page 3

CB+ Small Boat Cars can Convert to Fit Old-Style Non-CB Track
Important! Requires CB+ cars. See complete instructions at www.harken.com/manuals.
See traveler instructions 5070.
Track built after 2002. No need to convert car.
Track built before 2002.
Groove for
retaining clip
CB track
Non-CB track
Converting Small Boat CB + Cars to Fit Old-Style Non-CB Track
3. Remove retaining clips and corner keepers
over box to catch balls.
1. Use flat-bladed screwdriver to push retaining
clip toward end.
5. Remove two (2) clips from car loader.
Slide car loader in so loading port is on
the side of car without balls.
2. Pry retaining clip off and dump balls in box.
4. Hold car on edge and load lower side with
correct number of balls. DO NOT OVERLOAD.
Consult chart to confirm quantity.
6. Put one (1) clip on "open" end of loader.
Load rest of balls through ball loading port
into empty bearing race. Consult chart to
confirm quantity. Line up car loader with
track and gently roll car onto track. Do not
use corner keepers.
CB+ cars designed for CB track.
Order HSB116 car loader.
CB+ cars can convert to run
on old-style, non-CB track.