Harken 2700 Traveler - Manual (Page 2)

Installing Control Tangs on 2700, 2726, 2727 Traveler Cars
Primary Carbo mainsheet Control Carbo control
Car pin blocks pin blocks
2730 5 mm 57 mm: singles, fiddles 29 mm
2731 ( 3 /
16
") 40 mm: doubles, triples 4 mm
348
( 5 /
32
") 340
2735 6 mm 57 mm: doubles, triples 341
Primary
pin
Control
pins
Block Compatibility with: 2730, 2731, 2735 Toggle Cars and 2747, 2748 Stand-Up Toggles
Remove screw from car, add
drop of Loctite
® adhesive to
screw, insert, and install tang.
Note: 2705 control tang is
shown below.
Remove car
screws.
2705/2749
Control tangs
2705
Loctite is a registered trademark of Henkel AG & Company KGaA.
Position car on edge with retaining clip in place.
Gently push one (1) ball at a time into car from
center of clip. Allow balls to roll into return race
and insert remaining balls.
Do not overfill car.
Loading Ball Bearings into CB Cars
CB car Description
Balls/
car Balls
Order
part no.
Balls/
set Ø
2700, 2701, 2702, 2703 Micro 40 Torlon ® 2708 20 3 /
16
" (5 mm)
2726, 2728, 2730, 2732, 2753 Small Boat LL* 40 Delrin ® 176 21 1 /
4
" (6 mm)
2727, 2729, 2731, 2733, 2734, 2754, 2756 Small Boat 40 Torlon 177 21 1 /
4
" (6 mm)
2735, 2736, 2737, 2738, 382, 2757 Small Boat 1250 60 Torlon 177 21 1 /
4
" (6 mm)
*Low-load car
B Ball Replacement Chart
Delrin is a registered trademark of E. I. du Pont de Nemours and Company or its affiliates. Torlon is a registered trademark of Solvay Advanced Polymers.
Position car on edge and gently push one (1) ball at
a time from center of retaining clip. Do not remove
retaining clip from car.
Removing Ball Bearings from CB Cars