Harken 3867 System C CB Battcars: built 2008 to present - Manual (Page 8)

System C CB 8
7. Hold full-length track piece up to mast.
Loosely install top screw.
Use putty knife to slide additional slugs
and connector slug into place. Loosely
install all nineteen 8 x 25 mm screws.
8. Slide tracks up enough to fit next track.
Mast up: Hold upper tracks. Loosen screw
that holds tracks. Slide track up. If screws
bind in mast groove opening, loosen them
until track slides. Tighten new bottom
screw securely.
9. Repeat until all full-length tracks installed.
3855 endstop kit—leave bottom 432 mm
(17") track off until cars are installed.
Assembly Install Track
Note: If bottom full-length track blocks
feeder gap, load bottom track slugs before
installing track.
10. Raise tracks so 432 mm (17") bottom
feeder track fits.
11. Install bottom feeder track with stop.
CAUTION! Do not let tracks
drop. Severe injury to hands
and/or fingers can result.