Harken C7475 MKIII Jib Reefing & Furling - Manual (Page 4)

■ HEADSTAY CUT LENGTH
Subtract the following from the headstay length and cut the
stay at that point.
■ STRINGING CONNECTORS ON STAY
Make sure the trim cap is at the top and the correct number
of connectors are used. The long bottom connector must be
slid on the rod last.
■ ROD COLDHEAD HEIGHT
Make sure the length of coldhead does not interfere with the
drive pin.
Distance between the collet bottom and the rollpin is 6.5 mm
HEADSTAY CUT LENGTH CHART
22.2 mm 25.4 mm
-30 rod (11.1 mm) 187 mm —
-40 rod (12.7 mm) — 201 mm
HEADST
AY CUT LENGTH
PREPARATION Headstay Length
4 Nautor Furling December 2004
6.5 mm
Clevis Pin Size