Denon AVR-4800 - Manual (Page 40)

40
Playing the input source
1 3 5
2
1 Select the input source to be played.
INPUT SELECTOR CD
8
(Main unit) (Remote control unit)
Example: CD
When the tape 2 input (TAPE-2
MON) is selected, the input indicator
lights.
TAPE-2 MON
Lit
2 Select the input mode.
• Selecting the analog mode
Press the ANALOG button to switch to the analog input.
ANALOG
ANALOG
(Main unit) (Remote control unit)
• Selecting the external input (6CH/8CH EXT. IN) mode
Press the 6CH/8CH EXT. IN (on the EXT. IN button on the
remote control unit) to switch the external input.
6CH / 8CH
EXT. IN EXT.IN
(Main unit) (Remote control unit)
• Selecting the AUTO, PCM and DTS modes
The mode switches as shown below each time the INPUT
MODE button is pressed.
INPUT MODE
INPUT MODE
(Main unit) (Remote control unit)
AUTO PCM DTS
DVD
START LEARNED/TX
HOME THX CINEMA
TUNING
DOLBY / DTS
SURROUND DIRECT
DSP SIMULATION 5CH / 7CH STEREO STEREO
INPUT MODE ANALOG EXT.IN
MUTING
MASTER VOL.
VOLUME DISC SKIP+
SYSTEM CALL POWER
VDP TUNER SHIFT
TV/DBS V.AUX PHONO
VCR-1 CD MD / TAPE-1 CHANNEL
VCR-2 TAPE-2 MON TV/VCR
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD MD MULTI DECK
SYSTEM SETUP SURROUND PARAMETER
RC-869
1 2 3
4
SET
A / B
CALL OFF ON / SOURCE
5 6
7 8 9
+10 0
1
3
2
5
Input mode selection function
Different input modes can be selected for the different input sources.
The selected input modes for the separate input sources are stored
in the memory.
q AUTO (All auto mode)
In this mode, the types of signals being input to the digital and
analog input jacks for the selected input source are detected and
the program in the AVR-4800’s surround decoder is selected
automatically upon playback. This mode can be selected for all
input sources other than PHONO, TAPE-2 and TUNER.
The presence or absence of digital signals is detected, the signals
input to the digital input jacks are identified and decoding and
playback are performed automatically in DTS, Dolby Digital or
PCM (2 channel stereo) format. If no digital signal is being input,
the analog input jacks are selected.
Use this mode to play Dolby Digital signals.
w PCM (exclusive PCM signal playback mode)
Decoding and playback are only performed when PCM signals are
being input.
Note that noise may be generated when using this mode to play
signals other than PCM signals.
e DTS (exclusive DTS signal playback mode)
Decoding and playback are only performed when DTS signals are
being input.
r ANALOG (exclusive analog audio signal playback mode)
The signals input to the analog input jacks are decoded and
played.
t 6CH/8CH EXT. IN (external decoder input jack selection mode)
The signals being input to the external decoder input jacks are
played without passing through the surround circuitry.
NOTE:
• Note that noise will be output when CDs or LDs recorded in DTS
format are played in the “PCM” or “ANALOG” mode. Select the
“DTS” mode when playing signals recorded in DTS from a laser
disc player or CD player.
Note on playing a source encoded with DTS
• Noise may be generated at the beginning of playback and
while searching during DTS playback in the AUTO mode. If
so, play in the DTS mode.