Denon AVR-4800 - Manual (Page 39)

39
Clearing “learned” remote control signals
1 Press the USE/LEARN selector button with the tip of a pen,
etc., to set the learn mode.
2 To clear “learned” remote control signals, set the slide switch
to the position at which the signals were “learned”.
AVR/AVC VIDEO
AUDIO
3 Set the slide switch to the position at which the signals were
“learned”.
DVD TV
VDP VCR
CD
MD
MULTI
DECK
DVD
START LEARNED/TX
HOME THX CINEMA
TUNING
BAND
TITLE MENU/GUIDE
MODE
MEMORY
USE/LEARN T.TONE MULTI SPEAKER DVD
SET UP
RETURN
STATUS
DISPLAY
ON SCREEN
DOLBY / DTS SURROUND DIRECT
DSP SIMULATION 5CH / 7CH STEREO STEREO
INPUT MODE ANALOG EXT.IN
MUTING
MASTER VOL.
VOLUME DISC SKIP+
SYSTEM CALL POWER
VDP TUNER SHIFT
TV/DBS V.AUX PHONO
VCR-1 CD MD / TAPE-1 CHANNEL
VCR-2 TAPE-2 MON TV/VCR
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD
MD
MULTI
DECK
SYSTEM SETUP SURROUND PARAMETER
CH SELECT
SELECT
1 2 3
4
SET
A / B
CALL OFF
ENTER
ON / SOURCE
5 6
7 8 9
+10 0
4
2
1,5
3
4 Press the SYSTEM CALL SET button, and hold it in for at least
four seconds.
• When both the START and LEARNED/TX LEDs light
simultaneously, all the stored codes are cleared.
SET
Lit
5 Press the USE/LEARN selector button.
9 OPERATION
Before operating
1 Refer to “CONNECTIONS” (pages 6 to 15) and check that all
connections are correct.
2 Set the remote control unit’s slide switch to the AUDIO
position. (only when operating with the remote control unit)
AVR/AVC VIDEO
AUDIO
3 Turn on the power.
Press the POWER operation switch (button).
ON / STANDBY
ON / SOURCE
ON/STANDBY
Lights
(Main unit) (Remote control unit)
3
DVD
START LEARNED/TX
HOME THX CINEMA
TUNING
DOLBY / DTS SURROUND DIRECT
DSP SIMULATION 5CH / 7CH STEREO STEREO
INPUT MODE ANALOG EXT.IN
MUTING
MASTER VOL.
VOLUME DISC SKIP+
SYSTEM CALL POWER
VDP TUNER SHIFT
TV/DBS V.AUX PHONO
VCR-1 CD MD / TAPE-1 CHANNEL
VCR-2 TAPE-2 MON TV/VCR
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD
MD
MULTI
DECK
SYSTEM SETUP SURROUND PARAMETER
RC-869
1 2 3
4
SET
A / B
CALL OFF ON / SOURCE
5 6
7 8 9
+10 0
2
3
• When pressed, the power turns on and the display lights. The
sound is muted for several seconds, after which the unit operates
normally.
• When pressed again, the power turns off, the standby mode is set
and the display turns off.
• Whenever the ON/STANDBY button is in the STANDBY state, the
apparatus is still connected to the AC line voltage. Please be sure
to unplug the cord when you leave home for, say, a vacation.