Denon AVR-4800 - Manual (Page 19)

19
• Speaker system layout
Basic system layout (For a THX Surround EX system)
• The following is an example of the basic layout for a system consisting of eight speaker systems and a television monitor:
With the AVR-4800 it is also possible to use the surround speaker selector function to choose the best layout for a variety of sources and surround
modes.
Subwoofer Center speaker system
Surround speaker systems
Surround back speaker systems
Front speaker systems
Set these at the sides of the TV or screen with
their front surfaces as flush with the front of the
screen as possible.
• Surround speaker selector function
This function makes it possible to achieve the optimum sound fields for different sources by switching between two systems of surround
speakers (A and B). The settings of the different speakers (A only, B only or A+B) are stored in the memory for the different surround modes,
so they are set automatically when the surround mode is selected. In addition, since the setting of the surround back speakers (ON or OFF)
is stored separately for surround speakers A and B, it is possible to set either a multi surround speaker system (A) using the surround back
speakers or a single surround speaker system (B) for the different surround modes.
A A
B B
A A
B B
A A A A
Using A only
(Multi surround speaker system)
Using B only
(Single surround speaker system)
• It is also possible to select surround
speakers A+B, but we recommend using
the more effective multi surround speaker
system with the surround back speakers.
NOTES:
• The on-screen display signals are not output from the MONITOR OUT-2 output jack or the color difference (component) video signal (MONITOR OUT) jacks.
• The on-screen display signals are output with priority to the S-VIDEO MONITOR OUT jack during playback of a video component. For example, if the TV
monitor is connected to both the AVR-4800’s S-Video and video monitor output jacks and signals are input to the AVR-4800 from a video source (VDP, etc.)
connected to both the S-Video and video input jacks, the on-screen display signals are output with priority to the S-Video monitor output. If you wish to output
the signals to the video monitor output jack, do not connect a cord to the S-VIDEO MONITOR OUT jack. (For details, see page 30.)
• The AVR-4800’s on-screen display function is designed for use with high resolution monitor TVs, so it may be difficult to read small characters on TVs with small
screens or low resolutions.
• The setup menu is not displayed when headphones are being used.