Gullco GK-200-RL - Manual (Page 9)

7
OPERATION
Local Control Devices
The power On/Off switch is used to disconnect the power
to the rest of the control circuitry.
I = on, O = off.
WARNING! The motor control must not be continually
started and stopped by the removal and
reapplying of power to the control.
Turning the power off to the control will
not provide instant braking and continued
use will damage the control. Allow ten
(10) seconds after the removal of power
before reapplying the power to the motor
control.
The fuse holder allows accessibility to the main fuse by pushing the cap in towards the main body
and twisting in a counter-clockwise direction.
GSP-2100 Control Overview
On/Off Switch
Fuse Holder
Speed & Parameter Value
Display
Speed Display Calibrated in
Inches per Minute
Speed Display Calibrated in
Centimeters per Minute
Auto Cycle Mode (Constant)
Manual Mode (Absent)
Speed Adjustment
Counter-Clockwise = Slower
Clockwise = Faster
Neutral
Command Reverse Motion
Control in Run Mode
Cycle Push Button
Arc Signal Active
Hold (Stop) Mode Active
Reverse Motion Commanded
Forward Motion Commanded
Control in Hold (Stop) Mode
Command Forward Motion