Gullco GK-200-RL - Manual (Page 31)

T-1
IMPORTANT
READ THIS BEFORE OPERATING THE “GSP-2100” CONTROL
Read and understand the operation manual before operating or performing service of this
equipment. Become familiar with the machines operation, applications and limitations. Keep the
operation manual in a clean and readily available location.
The components used in these controls are Electrostatic Discharge Sensitive. Suitable ESD
precautions must be adhered to when handling the control. Failure to comply may result in
immediate or latent failure.
The motor control must not be continually started and stopped by the removal and reapplying of
power to the control. Turning the power off to the control will not provide regenerative braking and
continued use will damage the control.
Allow ten (10) seconds after the removal of power before reapplying the power to the "GSP" control.
The “Current Limit” (motor overload protection) on this product is typically factory pre-set to 10
Amps (unless specifically requested at time of order). If a specific application requires that this be
changed, please refer to the section which describes the “Motor Control Variable Adjustments”,
later in this manual.
The "GSP-2100" control has built in safety logic that reduces the risk of injury, damage and faulty
operation. When the “GSP-2100” control recognizes a potential problem, its LED’s display an error
code and the unit will not allow any motor output until the fault has been cleared and the control has
been reset (application of the hold command and pushing the cycle push button, or depending on
the circumstances, powering down & waiting 10 seconds before powering back up). The Error
Table on the following page lists the generic errors and their displayed error codes. Certain
product/application specific programs may have other error codes, specific to that unit, which are
not listed in this manual. Refer to the manual for the specific equipment/program for further details.