Delfield UCD4464N-24M - Manual (Page 4)

Exterior top is one-piece 22-gauge stainless steel
with integral 2.12” (5.4cm) square nosing on the front.
Telescoping lid is constructed of 20-gauge stainless steel.
Top of drawer unit has openings to accept 12, 18 or 24
1/6 size plastic pans 4” (10cm) deep. Top of door unit has
openings to accept 12, 18 or 24 1/6 size plastic pans 4” or
6” (10cm or 15cm) deep. Adapter bars and 1/6 size pans
are supplied by Delfield. Temperature in top openings
maintains 33°F (1°C) to 41°F (5°C), with pans recessed 2.5”
(6.4cm) at 86°F ambient room temperature, meeting NSF 7
requirements. One 64” x 8” x .5” (162.9cm x 20.3cm x 1.3cm)
polyethylene cutting board treated with antimicrobial
agent is mounted on the top at the front edge.
Dual level pan brackets allow the pans to be lowered
an additional inch in the unit without tools to provide
additional pan temperature holding performance.
Exterior back and bottom are two-piece 24-gauge
galvanized steel. Exterior ends are stainless steel.
Interior sides are thermoformed ABS plastic with shelf
supports. Base is fully insulated with high-density
foamed in place environmentally friendly, Kyoto Protocol
Compliant, Non ODP (Ozone Depletion Potential), Non
GWP (Global Warming Potential) polyurethane.
Refrigeration system uses hFC-404A refrigerant.
Compressor is 1/2 h.P., with condenser coil and hot gas
condensate evaporator mounted on rear of the cabinet.
Evaporator coil is located on the interior rear wall of the
cabinet. Refrigerant flow is controlled by a capillary tube.
Cabinet maintains an interior cabinet temperature of 36°F
to 40°F (2°C to 4°C).
ACT control: ACT electronic, solid state control, mounted
on the exterior rear of the cabinet, allows unit to maintain
precise temperatures in heavy duty conditions.
Specifications
UC4464N Mega Top
Reduced Height Front-Breathing Self-Contained Mega Top Refrigerated Bases
Electrical connections are 115 volt, 60 hertz, single
phase. Unit has a 6’ (1.8m) long electrical cord and NEMA
5-15P plug.
Casters: Equipment is mounted on 3” (7.6cm) diameter
plate casters. Equipment clearance above the floor is 0.66”
(1.7cm).
Doors have a 24-gauge stainless steel exterior, with
thermoformed ABS plastic interior liner. Cabinet has one
adjustable epoxy-coated wire shelf per door opening.
Drawers have 24-gauge stainless steel exterior with
thermoformed ABS plastic interior liner. Drawer frames
are 12-gauge stainless steel. Drawer slides are 11-gauge
stainless steel with stainless steel bearings. Each top
drawer holds two 12” x 20” (30.5cm x 50.8cm) pans 4”-6”
(10.2cm-15.2cm) deep. Each bottom drawer holds two 12”
x 20” (30.5cm x 50.8cm) pans 4” (10.2cm) deep. Pans are
supplied by others.
980 S. Isabella Rd.
Mt. Pleasant, Michigan 48858 Phone: 800-733-8948 or 989-773-7981
Fax: 800-669-0619
www.delfield.com Printed in the U.S.A.
DSUC4464N-M
03/13