beautypg.com

Delfield Salad Top STD4472N-12 User Manual

St4472n salad top, Models

background image

Project __________________________________

Item ____________________________________

Quantity ________________________________

CSI Section 11400

Approved _______________________________

Date ____________________________________

980 S. Isabella Rd.
Mt. Pleasant, Michigan 48858

Phone: 800-733-8948 or 989-773-7981
Fax: 800-669-0619

www.delfield.com

Exterior top is one-piece 22-gauge stainless steel with integral

2.12” (5.4cm) square nosing at the front. The backsplash is full

width and 4” (10cm) tall. Top of drawer unit has openings to

accept 12 1/6-size 4” (10cm) deep plastic pans. Top of door

unit has openings to accept 12 1/6-size 4” or 6” (10cm or 15cm)

deep plastic pans. Adapter bars and 1/6 pans are supplied by

Delfield. Temperature in top opening to maintain 33°F (1°C)

to 41°F (5°C), with pans recessed 2.5” (6.4cm) at 86°F ambient

room temperature, meeting NSF 7 requirements. One 72” x 10”

x .5” (183cm x 25.4cm x 1.3cm) polyethylene cutting board

treated with antimicrobial agent is mounted on the top at

the front edge.

Dual level pan brackets allow the pans to be lowered an

additional inch in the unit without tools to provide additional

pan temperature holding performance.

Exterior back and bottom are two-piece 24-gauge galvanized

steel. Exterior ends are stainless steel.

Interior sides are thermoformed ABS plastic with shelf

supports. Base is fully insulated with high-density foamed in

place environmentally friendly, Kyoto Protocol Compliant, Non

ODP (Ozone Depletion Potential), Non GWP (Global Warming

Potential) polyurethane.

Refrigeration system uses HFC-404A refrigerant. Compressor

is 1/2 H.P., with condenser coil and condensate evaporator

mounted on rear of the cabinet. Evaporator coil is located

on the interior rear wall of the cabinet. Refrigerant flow is

controlled by a capillary tube. Cabinet maintains an interior

cabinet temperature of 36°F to 40°F (2°C to 4°C).

ACT control: ACT electronic, solid state control, mounted on

the exterior rear of the cabinet, allows unit to maintain precise

temperatures in heavy duty conditions.

Electrical connections are 115 volt, 60 Hertz, single phase.

Unit has a 6’ (1.8m) long electrical cord and NEMA 5-15P plug.

Casters: Equipment is mounted on 5” (13cm) diameter plate

casters with front two locking. Equipment clearance above the

floor is 2.5” (6cm).

The following applies to three door models only. Doors

have a 24-gauge stainless steel exterior, with thermoformed

ABS plastic interior liner. Cabinet has one adjustable epoxy-

coated wire shelf per door opening.

The following applies to six drawer models only. Drawer

fronts have a 24-gauge stainless steel exterior, with

thermoformed ABS plastic interior liner. Drawer frames are

12-gauge stainless steel. Drawer slides are 11-gauge stainless

steel with Delrin bearings. Each section has two drawers. Each

top drawer holds one full size 12” x 20” (30.5cm x 50.8cm) pan

and three 1/9 size pans 4” - 6” (10.2cm -15.2cm) deep. Each

bottom drawer holds one 12” x 20” (30.5cm x 50.8cm) pan and

three 1/9 size 4” (10.2cm) deep pans. Pans supplied by others.

Specifications

Standard Features

Options &
Accessories

• Patented air screen ensures product stays cold

without drying it out

• All 4400 Series units are 100% front breathing,

which allows the unit to be pushed against a
wall or built into a cabinet or an existing line up

• Durable, rugged stainless steel sides, top and

front

• Features Delfield’s exclusive ABS interior (on

sides). ABS is extremely durable - it won’t dent,
chip or corrode and is backed by a limited
lifetime warranty

• Delfield supplies 1/6 size pans and positive

placement adapter bars for top opening

• Dual level pan brackets allow the pans to be

lowered an additional inch in the unit without
tools to provide additional pan temperature
holding performance

• Salad top refrigerators are standard with 10”

wide, dishwasher safe polyethylene cutting
board treated with antimicrobial agent

• “D” prefix models feature Delfield’s new drawer

system. Drawers are backed by a 10-year
warranty on the track assembly

• Environmentally friendly R404A refrigerant
• High density foamed in place environmentally

friendly, Kyoto Protocol Compliant, Non ODP
(Ozone Depletion Potential), Non GWP (Global

ST4472N-12

Three section with doors twelve pan capacity

STD4472N-12

Three section with drawers twelve pan capacity

Models

ST4472N Salad Top

Front-Breathing Self-Contained Salad Top Refrigerated
Bases

ST4472N Salad

Top: F
ront
-Br

eathing S

elf-
Contained Salad

Top R
efr

igerat

ed Bases

Warming Potential) polyurethane keeps
energy costs low

• Black recessed quick grip handle
• Standard on 5” casters for easy cleaning

and installation

• 6’ cord and plug supplied
• One epoxy coated wire shelf standard,

installed per door section

• ACT solid state electronic control
• "ST" models have a 4" stainless steel

backsplash

• Three year parts and labor warranty

and an additional two year compressor
parts warranty

• Flat lift off cover
• 18” wide single tier overshelf
• Stainless steel finish on back
• Plastic laminate on front
• Additional wire shelves
• 3” casters, 3.75” ride height
• Door lock
• Exterior thermometer
• 220V/50 Hertz electrical system*

* Inclusion of this option will alter electrical

specifications of the unit

STD4472N-12

This manual is related to the following products: