GAMMA 5800 Els STRINGING MACHINE 2 POINT SC MOUNTING (Issue 6 - July 2014) - Manual (Page 7)

7
The String Reel holder pin is an 8 mm rod
with threads on both ends and f at surfaces
machined on one end. Thread the end of the
pin without the f at surfaces into the threaded
boss on the right side of the Lower Column.
Using the M6 open end wrench positioned
on the f at surfaces, securely tighten the pin
to the Lower Column.
The String Reel Holder can hold up to 5 reels
of string (depending on the size of the string
reel). Before placing the f rst reel on the rod,
slide two M8 washers over the pin and slide
them to the boss on the Lower Column. After
the f rst reel is placed onto the rod, place
two spacers between each reel to provide
enough space between reels and allow them
to turn freely without rubbing against one
another. (To provide a smooth feed to the
String Length Meter, place the reels on the
rod so the string spools off the reel from the
underside of the reel).
After the last reel is installed, place the re-
maining spacer(s) on the pin and attach the
threaded knob to the end of the rod.
STRING REEL HOLDER INSTALLATION