GAMMA 5800 Els STRINGING MACHINE 2 POINT SC MOUNTING (Issue 6 - July 2014) - Manual (Page 27)

27
2pt Hold Down Clamp Adjustment
The 2pt racquet frame Hold Down Clamps
have been adjusted at the factory. However,
depending on the racquet frame thickness,
the Hold Down Clamp may require adjust-
ment. Use a 3 mm hex wrench and turn
the set screw clockwise to reduce the hold
down clamp pressure and counter clockwise
to increase the hold down clamp pressure.
Note: To avoid potential damage to the rac-
quet only make small adjustments at a time
by slightly turning the set screw by no more
than 1/4 of a turn. Test the hold down lever
to insure the racquet is held snuggly but
without applying excessive force to the lever .
Periodically clean the Hold Down Clamp pin using rubbing alcohol to remove residue or dirt,
that may build up over time.