Smartseries station 70v/100v speaker line monitor, General, Field wiring – GAI-Tronics ICS Zone 2/22 Weatherproof Page/Party Station User Manual
Page 26
Pub. 42004-734L2D
ICS Zone 2/22 Weatherproof Page/Party
®
Station
Page 24 of 33
f:\standard ioms - current release\42004 instr. manuals\42004-734l2d.doc
11/14
SmartSeries Station 70V/100V Speaker Line Monitor
General
The 70V/100V Speaker Line Monitor assembly provides the ability to connect several 70-volt or 100-volt
speakers to a single ICS SmartSeries Station. Speakers are wired in parallel to the station. When used
with an ADVANCE head-end cabinet, the speaker line can be monitored by looping it back to the ICS
SmartSeries Station. Refer to Figure 18 above and Figure 20 on page 25.
N
OTE
: SmartSeries ALS and local speaker monitoring are not available when the 70V/100V
speaker output option is installed and must be disabled for this station in the system configuration.
Field Wiring
For 100V speakers, connect wires to the plug for TB8 - 100V and COM.
For 70V speakers, connect wires to the plug for TB8 - 70V and COM.
N
OTE
: Use of the 8/16-ohm speaker output or TB1 will affect maximum speaker power output.
Figure 19. 70V / 100V Speaker Connections