GAI-Tronics 723-901 SmartSeries Remote Subset Amplifier - Manual (Page 2)

Pub. 42004-326C
Model 723-901 SmartSeries
®
Remote Subset Amplifier Page 2 of 13
f:\standard ioms - current release\42004 instr. manuals\42004-326c.doc
03/12
Features and Functions
The Model 723-901 Remote Subset Amplifier provides the following features when installed in a
SmartSeries
® ADVANCE system:
 Enables one-way paging from the remote
subset handset. Priority Page feature
enables important messages to override
operational communication
 SmartVolume™ feature measures the ambient
noise and automatically adjusts the speaker output
level (desk-edge and flush-mount stations only)
when used with externally connected speaker
 Enables two-way party line communication
from the remote subset handset
 Contains page amplification to broadcast
announcements over the station’s speaker
 Monitors and controls off-hook and page
status of the remote subset handset. Limits
off-hook and page durations to prevent open
microphone and nuisance page problems
 Monitors and reports problems with handset
amplifier, the speaker amplifier, and speaker voice
coil to the MCU
 Supervises the externally connected speaker
(desk-edge and flush-mount stations only)
 Monitors and reports the status of the auxiliary
inputs
Optional Features
The following features are available as options to the standard configuration of a station used in a
SmartSeries
® ADVANCE system and installed in a special enclosure. Contact the GAI-Tronics Field
Service Department at (800) 492-1212 inside the USA or (610) 777-1374 outside the USA for further
information about these features.
 The Selected Page Destination feature allows the manual selection of up to four page destinations.
 The Supervised Input feature allows the monitoring and supervision of one or two initiating device
circuits (IDCs), initiating an alarm when the supervised device is activated.
 The Power Relay Module provides a relay contact output, typically to switch power to a visual
signaling device, for directed or relay group operation. Supervision of the controlled device’s cable
can also be enabled.
 The Station Emergency Party Line feature supports annunciation for two party lines.