Acpi configuration – Foxconn Z75M-S User Manual

Page 34

ACPI Configuration

Security

Main

Boot

OC plus

Save&Exit

Advanced

Select ACPI sleep state

the system will enter when

the SUSPEND button is

pressed.

→ ←: Select Screen

↑ ↓/Click: Select Item

Enter/Dbl Click: Select

+/-: Change Opt.

F1: General Help

F2: Previous Values

F3: Optimized Defaults

F4: Save & Exit

ESC/Right Click: Exit

ACPI Configuration

ACPI Sleep State

[S3]

Restore on AC Power Loss

[Power Off]

Deep Sleep Mode

[Enabled]

Resume by RTC

[Disabled]

Wake on USB Device

[Enabled]

Wake on PCI/PCIe device

[Enabled]

Wake on PS/2 KB from S1 and S3

[Enabled]

► ACPI Sleep State

This item is used to set the energy saving mode of the ACPI function. When you select
“S1(POS)” mode, the power is always on and computer can be resumed at any time. When
you select “S3 (STR)” mode, the power will be down after a period of time. The status of
the computer before it entering STR will be saved in memory, and the computer can quickly
return to previous state when the STR function wakes.When you select “Auto”, it means OS
will automatically take care and assign which mode is the most suitable now.

► Restore on AC Power Loss

This item is used to set which state the PC will take with when it resumes after an AC power
loss.

► Deep Sleep Mode

This item is used to enable or disable the deep sleep mode. Disabling this function will
reducing system power consumption when computer go into power off state.

► Resume by RTC

This item is used to enable or disable System wake on alarm event. When enabled, System
will wake on the day hr::min::sec specified. When you set ‘Deep Sleep Mode’ to [Enabled]
and set this item to [Enabled], only S1/S3 state can be wake up.
RTC is system real time clock.

► Wake on USB Device

This item is used to control the wake on USB device function from S1/S3/S4 State. When
you set ‘Deep Sleep Mode’ to [Enabled] and set this item to [Enabled], only S1/S3 state can
be wake up.

► Wake on PCI/PCIe Device

This item is used to control the wake on PCI/PCIe device from S3/S4/S5/G3 function and
S1 not support wake. When you set ‘Deep Sleep Mode’ to [Enabled] and set this item to
[Enabled], only S3 state can be wake up.

► Wake on PS/2 KB from S1 and S3

This item is used to enable or disable PS2 key board wake up from S1 and S3 state.

BIOS SETUP