Dynex DX-E401 - Manual (Page 10)

10
To reset the system settings to factory defaults, please follow these steps:
Leave the device powered on, do not disconnect the power
Press the reset button and hold (use a paper-clip)
Keep the button pressed about 10 seconds
Release the button
The DX-E401 will then automatically reboot itself.
Reset
Getting Started
Installation Location
The DX-E401 can be positioned at any convenient place in your office or house.
No special wiring or cooling requirements are needed. However, you should
comply with the following guidelines:
Place the DX-E401 on a flat horizontal plane.
Keep away from any heating devices.
Do not place in a dusty or wet environment.
The recommended operational specifications of the DX-E401 are:
Temperature 32 o F ~ 131 o F
Humidity 5 % ~ 90 %
In addition, remember to turn off the power, remove the power cord from the
outlet, and keep your hands dry when you install the hardware.