Foxconn NFPIK8AA-8EKRS - Manual (Page 65)

57
Chapter 3 BIOS Description
Soft-Off by PBTN (Default: Instant-Off)
This item is used to set the power down method. This function is only valid
for systems using an ATX power supply.
When “Instant-Off” is selected, press the power switch to immediately turn off
power. When “Delay 4 Sec.” is selected, press and hold the power button for
four seconds to turn off power.
PME# From Soft-Off (Default: Enabled)
When set to Enabled, the feature allows your system to be awakened from the
power saving modes through any event on PME (Power Management Event)
WOR (RI#) From Soft-Off (Default: Enabled)
If this item is enabled, it allows the system to resume from a software power
down or power saving mode whenever there is an incoming call to an in-
stalled fax/modem. This function needs to be supported by the relevant hard-
ware and software.
AC Loss Feature (Default: Always Power Off)
This item is used to set the AC Loss fuature.
POWER ON Function (Default: BUTTON ONLY)
This item is used to set the power on method for your PC.
KB Power ON Password
When the POWER ON Function is set to Keyboard, use this item to set the
password.
Hot Key Power ON (Default: Ctrl-F1)
When the POWER ON Function is set to Hot KEY, use this item to set the
hot key combination that turns on the system.
Power-On by Alarm (Default: Disabled)
This item is used to set the timing of the start-up function. In order to use this
function, the start-up password function must be cancelled and the PC power
source must not be turned off.
Day of Month Alarm
When the Power-On by Alarm set as Enabled, this option will be modified. It
is used to set the timing for the start-up date.
Time (hh:mm:ss) Alarm
When the Power-On by Alarm set as Enabled, this option will be modified. It
is used to set the timing for the start-up time.