Formax FD 4170 - Manual (Page 8)

4
V 11
● Operation Panel
No. Name Function
1 - key Value (cut size) on the LCD display is decremented.
2 + key Value (cut size) on the LCD display is incremented.
3 Slow down key Processing speed gets slow.
4 Speed up key Processing speed gets fast.
5 JOG key The machine runs slowly while this key is depressed.
6 START key
Press to start operation.
* This key is inoperative when an error is displayed or no paper is
set.
7 STOP/C key
Press to stop operation.
When this key is pressed after the cause of paper JAM is solved
while the machine stops due to paper jam, the indicator will be
reset.
1 2 3 4 5 6 7
Number Description Function
1 “-” Button Use to decrease cut size on LCD display
2 “+” Button Use to increase cut size on LCD display
3 Decrease Speed Button Decreases processing speed, also used to select Presets
4 Increase Speed Button Increases processing speed, also used to select Presets
5 JOG Button Press this to process one sheet of paper
6 START Button Press to start operation. NOTE: This button is inoperative when an
error is displayed, or no paper is in the infeed tray.
7 STOP/C Button Press to stop operation. NOTE: When this button is pressed after a
paper jam is cleared, the indicator will be reset.
CONTROL PANEL
ADJUSTING PROCESSING SPEED
To adjust between speed levels, press either of the speed
buttons. Speeds include 42, 64, 89, 114, or 140 sheets per
minute.
To decrease speed, press the left SPEED button.
To increase speed, press the right SPEED button.
■
Usable Paper
Paper size
Vertical: 2.5-17inch
Width: 3-11inch
Paper thickness
58-157gsm
Paper stack capacity
350 sheets (thickness: 58gsm)
Capacity may change depending on paper alignment or curl.
[ NOTES ]
The following paper cannot be used.
* Paper with holes for filing
* Paper with staples and/or clips
* Paper with curl or crease
* Paper with carbon
* Paper with cut and paste
* Paper with glue or adhesive applied to sticker or tuck and so on.
■
Adjusting Processing Speed
5 speed levels are adjusted by pressing the speed key.
Gets faster by pressing the speed up key.
Gets slower by pressing the slow down key.
15
■
Turning ON the Power
1. Connect the ‘female plug’ of the power cord to
the ‘inlet’.
2. Connect the ‘male plug’ of the power cord to
the ‘outlet’.
3. Press the “I” side of the power switch.
The power to the machine turns on.
4. When the power is turned on, “HE110” appears Display when the power is on
on the LCD.
■
Turning OFF the Power
Press the “O” side of the power switch.
The power to the machine turns off.
18
POWERING UP
1. Plug power cord into inlet on Infeed Side of burster.
Plug into wall outlet with appropriate power capacity.
2. Press power switch to the “I” position.
3. When the power is turned on, “HEll0” appears in the
LCD area of the control panel.
4. To turn off power, press switch to “O” position.