Formax FD 4170 - Manual (Page 12)

8
LOADING PAPER
1. Fan the sheets to loosen, which will decrease static
electricity and reduce the chance of a paper jam or
misfeed.
2. Lower the up/down lever on the paper feed tray and
place the paper on the tray. Adjust the paper feed
guides on both sides, then tighten the setscrews.
3. Adjust the paper feed pressure adjustment lever to the
thickness of the paper. Usually it is set to “NORMAL.”
If the paper cannot be fed, set the pressure adjust lever
to “HEAVY.”
If double feeding occurs, set the lever to “LIGHT.”
4. Raise the up/down lever.
■
Setting Paper
1. Fan the air into sheets by riffling.
[ IMPORTANT ]
Loosing papers can reduce static electricity on the
paper and prevent from paper jam or misfeed.
* Refer to “ ■ Usable Paper“ on page 15.
2. Lower the up/down lever for the paper feed tray
and place the paper to be burst on the paper feed
tray.
Readjust the paper feed guides at both sides
without pressing the paper to be burst.
Then, tighten the setscrew.
3. Adjust the paper feed pressure to the thickness of
paper. Usually it is set to “NORMAL” position.
● When paper cannot be fed, set the paper feed
pressure adjust lever to “HEAVY” position.
● When double feed occurs, set the paper feed
pressure adjust lever to “LIGHT”.
4. Raise the up/down lever.
21
■
Setting Paper
1. Fan the air into sheets by riffling.
[ IMPORTANT ]
Loosing papers can reduce static electricity on the
paper and prevent from paper jam or misfeed.
* Refer to “ ■ Usable Paper“ on page 15.
2. Lower the up/down lever for the paper feed tray
and place the paper to be burst on the paper feed
tray.
Readjust the paper feed guides at both sides
without pressing the paper to be burst.
Then, tighten the setscrew.
3. Adjust the paper feed pressure to the thickness of
paper. Usually it is set to “NORMAL” position.
● When paper cannot be fed, set the paper feed
pressure adjust lever to “HEAVY” position.
● When double feed occurs, set the paper feed
pressure adjust lever to “LIGHT”.
4. Raise the up/down lever.
21