Formax FD 4170 - Manual (Page 19)

15
ERROR DISPLAY GUIDE
■
Error Display
* 2 error displays appear in turn.
Display
Status and Solutions
Status:
Paper jam in the paper feed part
Solutions: Check the paper feed tray and remove jammed paper.
After removing the jammed paper, press the STOP/C key
to clear the error display.
[ FEEd ]→[ Err. ]
Details: Refer to the How to deal with “[ FEEd. ]→[ Err. ]” on
page 32.
Status: Safety cover is open.
Solutions: Close the safety cover.
[ OPEn ]
Details: Refer to the How to deal with “[ OPEn ]” on page 33.
Status: No paper is set.
Solutions: There is no paper in the paper feed tray. Place the paper
in the paper feed tray or press the STOP/C key.
[ SEt ]→[ PAPE. ]
Details: Refer to the How to deal with “[ SEt ]→[ PAPE. ]” on
page 33.
Status: Paper remains inside the machine (cut part).
Solutions: Remove the paper and press the STOP/C key to clear the
error display.
[ PAPE. ]→[ LEFt ]
Details: Refer to the How to deal with “[ PAPE. ]→[ LEFt ]” on
page 34.
Status: Cut error
Solutions: Remove the paper in the cut part or paper ejection part
and, press the STOP/C key to clear the error display.
[ Cut ]→[ Err. ]
Details: Refer to the How to deal with “[ Cut ]→[ Err. ]” on page
34.
Status: Paper jam in the paper ejection part
Solutions: Remove the paper in the cut part or paper ejection part
and, press the STOP/C key to clear error display.
[ PASS ]→[ Err. ]
Details: Refer to the How to deal with “[ PASS ]→[ Err. ]” on
page 34.
Status: Main motor lock (Paper remains in the cut part or paper
ejection part.)
Solutions: Remove the paper and press the STOP/C key.
[ Err.1 ]
Details: Refer to the How to deal with “[ Err.1 ]” on page 35.
Status: Overload [ Err.5 ]
Solutions: Turn off the power to the machine and leave it for over 3
hours.
Others Solutions: Turn off the power to the machine and then turn it on after
a few seconds. If the same error message is displayed,
note the error content and contact our service person.
31
16
17
16
18
18
18
19