Formax 6600 Series - Manual (Page 46)

46
10.4 Error codes
error description suggested solution information Error code
To many sheets in set. Remove the documents and
complete the set manually. Set size exceeded. 3 : 110
Reading error. Remove the documents and
complete the diverted set
manually. Occurs when the
reading feeder is empty, the
set is not finished and the
clear key is pressed. After the
set is diverted this error is
given. Incomplete set. 3 : 111
Reading error. Remove the documents and
adjust the 1st mark from the
top position correctly. Wrong window position. 3 : 112
Reading stop. Remove the documents and
complete the diverted set
manually. Stop mark read. 3 : 113
Reading error. Note: reverse reading is used.
Remove the diverted
documents and complete the
set manually. Press reset to
remove the error message
and press "start" to resume
operation. Unexpected accumulate
mark read. 3 : 115
Reading error. Remove the documents and
adjust the reading head.
Adjust the1st mark from the
top position correctly. When
the error still occurs, contact
your service organization. Not enough marks. 3 : 120
Reading error. Remove the documents and
check the used OMR code. Mulitple basic command. 3 : 121
Reading error. Remove the documents and
check the used OMR code
(flex-dongle). No commands in code 3 : 122
Service assistance is needed for the error codes with the message “technical failure”. First write down
the error code, than switch the inserter off and on again, to verify system operation. When the error still
occurs contact your service organization.