Formax 6600 Series - Manual (Page 16)

16
Press and hold key 1 in the “inserting” menu for
job information.
Refer to the section "Display" for the operating
functions.
AutoSet™
After pressing key 5 in the “main menu (1)”, the
“AutoSet™” menu is shown.
Before starting the AutoSet™ function (see
figure below) the adjustment of the envelope
feed must be made manually to obtain correct
operation.
The AutoSet™ function can be used when a
required job is not available within the list of
jobs. The system automatically detects the
required feeders, document and envelope size
and it will determine the necessary fold settings.
The AutoSet™ screen shows the following
functions:
• get more info regarding AutoSet™.
• feed an envelope to the insert table.
• make one insert.
• set the insert position (= envelope stop
position) to the right.
• set the insert position to the left.
When special feeders are present, the
adjustment of the document feeders must be
made manually.
Only the address position can be adjusted if
needed.
The document will be folded and inserted in the
envelope.
The address carrier must be put into the upper
feeder.
Testset run
Press key 3 to start a testset run in the AutoSet TM
screen (see figure above). The settings of
the testset run will be saved. The machine
prepares a job 0 which is named AutoSet™.
Only the feeders that feed successfully will be
selected. If needed adjust the address position.
In the next screen shown the address position
can be altered as follows (see figure below):
• press key 4 to adjust the address a little
higher. Each key stroke brings the address up
1mm (0.04 inch) with a maximum of 12 mm
(0.48 inch) higher.
• press key to 5 adjust the address a little lower.
Each key stroke brings the address down
1mm (0.04 inch) with a maximum of 12 mm
(0.48 inch) lower.
If the required address position is beyond the
maximum range of 24 mm (0.96 inch), the
AutoSet™ function can not be used. Use a
programmed job instead.
In the AutoSet TM job the following options
cannot be used:
• feeder swap (the machine switches
automatically to the upper feeder when the
lower feeder is empty and vice versa).
• multifeed (more sheets are fed from the same
hopper into the envelope),
• processing an AutoSet TM job without using
envelopes (fold only).
• exit settings other than the "Stacker exit"
setting.
• the daily mail function.