Formax 6600 Series - Manual (Page 17)

17
ENGLIS
H
• DFC settings other than for the address
carrying feeder.
• the OMR function.
When an AutoSet™ job is defined
successfully these settings can be stored into a
job (refer to "Copy job" menu).
5. JOB PROGRAMMING
For an overview of the complete "create job" or
"edit job" menu structure refer to the section
"Job edit menu structure".
5.1 Job menu
After pressing key 4 in the "main menu (2)", the
display shows the "job access" screen and asks
for a pin code to enter (see figure below).
Enter the pin code with the keys 1 through 6.
When a wrong pin code is entered, the cursor is
set to the first number to try again.
After 3 times entering a wrong pin code the
display shows the "main menu (1)" again.
When the correct pin code is entered the "job
menu" is shown. The “job menu” shows the
following functions (see figure below):
• Job information ( ).
• Create a job.
• Edit a job.
• Copy a job.
• Delete a job.
• Exit and go back to the “main menu (1)”.
Press the escape key to get back to the
previous menu.
5.2 Create job menu
After pressing key 2 in the "job menu" the
"Create job" menu is shown. The display will
start with the lowest free job number available.
Job numbers already programmed will not be
shown. The "create job" menu shows the
following functions (see figure below):
• choose a higher free job number.
• choose a lower free job number.
• select the desired job number and confirm
with "OK" which will get you to the "job
settings" menu.
If all jobs are used the display shows "no more
free jobs".
To get a free job one has to be deleted.
A new selected job number starts with default
settings.
5.3 Edit job menu
After pressing key 3 in the "job menu" the "Edit
job" menu is shown. The "edit job" menu shows
the following functions (see figure below):
• Job information ( ).
• choose a higher job number to edit.
• choose a lower job number to edit.
• select the job to edit and confirm with "OK"
which will get you to the "job settings" menu.