Formax 6600 Series - Manual (Page 39)

39
ENGLIS
H
8.5 Feeding documents
The feeding of documents is shown in the figure below.
9. MAXIFEEDER
9.1 Function
The MaxiFeeder is intended to be used for
Business Reply Envelopes (BRE), but also
"standard" documents can be processed with it.
The MaxiFeeder ensures a higher document
capacity and thus a higher productivity.
9.2 Preparations
The MaxiFeeder should be installed at the
position of feeder station 1.
It can be placed into position in the same way as
the other document hoppers (see figure below).
Proceed as follows:
• lift the paper feed rollers with the front edge of
the MaxiFeeder.
• move the MaxiFeeder forward until it hooks
behind the frame axle.
• connect the connector A to the socket B.
As the MaxiFeeder is auto-detected by the
system when it is switched on, it is very easy to
switch over from the standard document hopper
to the MaxiFeeder and vice versa.
Note: To allow easier hooking on of the
MaxiFeeder it is advised to put the feeding plate
in the rear position (see section "Separation").
To make use of a MaxiFeeder it is not necessary
to (re-)program the jobs. The MaxiFeeder is
auto-detected by the system.
hopper swap two documents document + enclosure one document
no fold
single fold
zig-zag fold
Address carrier in
top feeder.
Face up and trailing. Address carrier in top linked
pair feeders.
Face up and trailing. Address carrier in
top feeder.
Face up and trailing. Address carrier in top
feeder.
Face up and trailing.
A B