Fluke Biomedical RF303 - Manual (Page 62)

RF303
Operators Manual
3-26
Table 3-2. Available Duplex Mode Commands (cont.)
Command Description Parameters
Required
Return Value
(Response)
Prompts the Analyzer to
return all measurements
of the applied signal of
the ESU.
{MODE=OUTPUT}
None I=AAAA(mA),
CF=XX.X,
KVPP=XXX,
PWR=PPP.P(w)
Where AAAA is the
Current reading in
milliamps, XX.X is the
Crest Factor, XXX is
the peak-to-peak
voltage in kVolts and
PPP.P is the power in
watts
Prompts the Analyzer to
measure the applied
signal current of the
ESU.
{MODE=RFLKG}
None I=AAAA(mA)
Where AAAA is the
Current reading in
milliamps.
Prompts the Analyzer to
return the current test
load.
{MODE=RARF}
None REM RESISTANCE=
RRR
Where RRR is the
load value in ohms.