Fluke Biomedical RF303 - Manual (Page 60)

RF303
Operators Manual
3-24
Table 3-2. Available Duplex Mode Commands (cont.)
Command Description Parameters
Required
Return Value
(Response)
RDMODE Prompts the Analyzer to
transmit the currently
selected mode.
None NONE
OUTPUT
RFLKG
RARF
EXITMODE Prompts the Analyzer to
exit the currently
selected mode.
Note: You must exit the
current mode before
entering another.
None *
SETLOAD:{parm} Sets the measurement
test load resistance from
50-750 ohms in 50 ohm
increments. Not
available in RFLKG
mode.
Values of 50-
750 in
increments of
50
*
RDLOAD Resistance value of the
selected test load
appears in the display.
None RRRR (ohms)
Where RRRR is the
load value in ohms.
Formatted to four
digits with leading
spaces as required.
RDPOWER Prompts an Analyzer
power measurement in
watts. Not available in
RFLKG and RARF
modes.
None PPP.P (w)