Fluke Biomedical RF303 - Manual (Page 50)

RF303
Operators Manual
3-14
WATTS
mA
OHMS
ENT
MODE SELECT OHMS SELECT
exz07.eps
To measure the ESU’s signal HF leakage:
1. If the mA indicator lamp on the panel is lit, go to Step 2. If it is not lit,
press the MODE SELECT ( ENT ) button to select mA and go to Step 2.
2. Activate the ESU and view the signal HF leakage measurement in
milliamperes on the display. Here is an example.
WATTS
mA
OHMS
ENT
MODE SELECT OHMS SELECT
exz18.eps
To end HF leakage test number two:
Deactivate the ESU to end the HF leakage test.
W Caution
To avoid damage to the Analyzer and the ESU under test,
do not exceed the Analyzer’s duty cycle, which is 30
seconds ON during any continuous one-minute period.