Flowserve 420 IOM - Manual (Page 26)

User Instructions - Logix® 420 Series Digital Positioners FCD LGENIM0106-06 12/13
flowserve.com
26
10.3.10 Configuration (Burst Mode)
Burst Mode continuously transmits HART information.
On/Off
– Use this feature to turn burst mode on and off.
10.3.11 Configuration (Positioner Revs)
Positioner revisions are shown in this menu.
SW Rev
–The revision of the embedded software.
Bld Date –The date of the embedded software build.
Bld Time –The time of day of the embedded software build.
HW Rev –The revision of the main board.
CPU Rev – The revision of the CPU.
HART Ver –The revision of the HART protocol (5, 6, or 7).
10.3.12 Configuration (Factory Reset)
At times, it may be convenient to reset all of the variables
to a default state. In this case, perform a Factory Reset.
Factory Reset – Use this feature to reset all variables to
their factory default state. All of the internal variables
including calibration will be reset to factory defaults. The
positioner must be re-calibrated after a factory reset. Tag
names and other user configured limits, alarm settings, and
valve information will also be lost and will need to be
restored. A factory reset will always reset the command
source to analog 4-20 mA.
CAUTION: Performing a factory reset may result in the
inability to operate the valve until reconfigured properly.
Notify proper personnel that the valve may stroke, and
make sure the valve is properly isolated.
10.3.13 Language
The display menu is available in several languages.
NOTE: To navigate directly to the language menu,
select the
following sequence of buttons: ▲Up ,
▲Up, ►QUICK-CAL/ACCEPT.
►Configuration
►Burst Mode
►On/Off
►Configuration
► Positioner Revs
► SW Rev
► Bld Date
► Bld Time
► HW Rev
► CPU Rev
► HART Ver
►Configuration
► Factory Reset
► Language
►English
►German
►French
►Spanish
►Portuguese
►Russian
►Turkish
►Italian