ETA Biopot User Manual
Page 41

Cleaning/replacement of gasket B4 (lid)
Gradually remove the gasket from the holder (i.e. the retaining ring) and the inner side of
the lid by gently pulling it out. Clean the gasket. If the gasket is worn or damaged replace
it with a new one (same type). Insert the gasket in the reverse sequence behind the holder
B6 as far as it will go.
Cleaning/replacement of grommet B3 (safety valve)
From the inner side of the lid gently pull the grommet
B3 from valve B2. Clean the
grommet. If the grommet is worn or damaged replace it with a new one (same type). In the
reverse sequence insert the grommet into the valve groove.
ATTENTION: The valve must
be able to move freely in the lid!
Cleaning/replacement of grommet B12 (steam pressure limit valve)
Pull out the steam limit valve cover
B4 from the outer side of the lid. Gently pull the cover
B8 from the inner side of the lid. Using a suitable tool (e.g. size 14 spanner) unscrew the
nut
B9, then remove the washer B10, cover holder B11 and the grommet B12. Clean all
the parts. If the grommet is worn or damaged replace it with a new one (same type). In the
reverse sequence assemble the individual parts in the correct order and position (pull the
nut tight with appropriate force).
ATTENTION
- Ensure that the contact surface and the sealing elements are in order. Never dry plastic
moulded parts above a heat source (e.g.
fire stove, electric/gas stove).
- Some foods may stain the accessories in a certain way. This however has no effect on
the operation of the appliance and is not cause for a claim or complaint regarding the
appliance! After some time this staining usually goes away by itself.
Storage
Before storing make sure that the pressure cooker is cool. Insert accessories
E into the
cooking pot
C. Store the pressure cooker in a safe dry location, out of the reach of children.
V. TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The pressure
cooker is not
working
The power is not connected
Check the power cord, plug and
el. socket
It is not possible to
seat or secure the
lid on the pressure
cooker
Gasket
B5 is not in its place
Place the gasket in the correct
place in the lid
Safety valve
B2 is in the up
position
Check the grommet
B3 and
if necessary clean it (see
Maintenance)
Using a suitable tool (e.g.
skewer) push the safety valve
into the down position
41
GB
/ 70