DR Power 22-Ton (July 2013 - Present) - Manual (Page 18)

18 DR ® VERTICAL/HORIZONTAL LOG SPLITTER
STEP 10: INSTALLING THE CROSS WEDGE KIT (OPTIONAL ACCESSORY).
1. Insert the cross wedge (14-1) to the rectangular hole on the splitting wedge (Figure 12).
2. Align the holes on the cross wedge, splitting wedge and the L-shape supports (14-2).
3. Loosely install the L-shaped supports to the splitting wedge with a bolt (14-3) and locknut (14-4) using two 13mm
wrenches.
4. Secure the L-shaped supports to the cross wedge with two bolts (14-5), lock washers (14-6) and flat washers (14-7) using a
13mm wrench.
5. Finish tightening the hardware to secure the L-shaped supports to the splitting wedge.
(Figure 12)
Splitting Wedge
REF. NO. DECSRIPTION QTY.
14
...............
Cross wedge assembly package (not shown)
..........
1
Including
14-1
............
Cross wedge
.........................................................
1
14-2
............
L-shape support
....................................................
2
14-3
............
Hex head bolt / M8 x 55
.........................................
1
14-4
............
Lock nut / M8
........................................................
1
14-5
............
Hex head bolt / M8 x 25
.........................................
2
14-6
............
Lock washer / M8
..................................................
2
14-7
............
Flat washer / M8
...................................................
2