DR Power 22-Ton (July 2013 - Present) - Manual (Page 11)

CONTACT US AT www.DRpower.com 11
Note: The horizontal beam lock (7-1) must be installed with the handle on the right side of the splitter as shown (Figure 5). The slot in
the beam bracket will only latch properly to the handle if it on the right side.
4. Attach the horizontal beam lock to the tongue (6) with two bolts (7-2), four flat washers (7-3) and lock nuts (7-4) using a
17mm wrench for the bolt and a 18mm wrench for the lock nut.
5. Attach the tongue (6) to the reservoir assembly with two bolts (7-2), four flat washers (7-3) and lock nuts (7-4) using a 17mm
wrench for the bolt and a 18mm wrench for the lock nut.
(Figure 5)
REF. NO. DECSRIPTION QTY.
6 .................. Tongue & Jack stand assembly ............. 1
7 .................. Hardware Kit #3 (not shown) .............. 1
Including:
7-1 ............... Horizontal beam lock ........................... 1
7-2 ............... Hex head bolt / M10 x 80 ..................... 4
7-3 ............... Flat washer / M10 ................................. 8
7-4 ............... Lock nut / M10 ...................................... 4