DR Power 22-Ton (July 2013 - Present) - Manual (Page 13)

CONTACT US AT www.DRpower.com 13
STEP 5: ATTACHING THE ENGINE ASSEMBLY TO THE ENGINE MOUNT PLATE ON THE RESERVOIR ASSEMBLY.
Note: The 6.5 HP engine uses M8 hardware and the 9 HP engine uses M10.
The 6.5 HP engine mounts to the smaller 4-hole pattern. The 9 HP engine mounts to the larger 4-hole pattern.
1. For the 22-Ton and 28-Ton, install the engine to the engine mount with four bolts (10-1), eight flat washers (10-2) and four
locknuts (10-3) using two 13mm Wrenches (Figure 7).
2. For the 34-Ton, install the engine to the engine mount with four bolts (10-1), eight flat washers (10-2) and four locknuts (10-3)
using two a 16mm wrench for the bolt and a 17mm wrench for the locknut (Figure 7).
(Figure 7)
REF. NO. DECSRIPTION QTY.
10 ............... Hardware kit #5 (not shown) ....................... 1
Including:
10-1 ............. Hex head bolt / M8 x 40 (22 and 28 Ton) ....... 4
................... Hex head bolt / M10 x 40 (34 Ton) ................ 4
10-2 ............. Flat washer / M8 (22 and 28 Ton) ................. 8
................... Flat washer / M10 (34 Ton) ......................... 8
10-3 ............. Lock nut / M8 (22 and 28 Ton) ..................... 4
................... Lock nut / M10 (34 Ton) ............................. 4