DR Power Tow-Behind 9.59 Premier (September 2014 - Present) - Manual (Page 17)

CONTACT US AT www.DRpower.com 17
27. Wrap the Enclosure Flap tightly around the Tube Frame Handle at the rear
and secure the Velcro Strips (Figure 43).
28. Insert the Eyebolt through hole in the Enclosure at the front and into the hole
in the Top Tube Frame (Figure 44). Secure with a Knob on the inside.
29. Tighten the 10 Retainer Stud Locknuts you installed in step 9 using a 7/16"
Wrench.
30. Fully tighten all Knobs. Make sure the Top Tube Knobs inside the Collector
are turned so they do not push into the Enclosure Fabric.
31. Turn the Enclosure over so it is right side up.
32. Close the Cart onto the Frame until the Dump Lever holds it down.
33. With the help of another person, place the Collector onto the Cart and align
the Hinge Halves (Figure 45).
34. Insert the Hinge Pin through the holes in the Hinges (Figure 45). The fit may
be tight for this initial setup. Use a hammer to tap the Pin in if necessary.
35. Insert Hitch Clips in the holes at the ends of the Pin to secure it (Figure 46).
36. Pull the Enclosure Sleeve around the Outlet Chute (Figure 47).
37. Attach the Cable Link to the Enclosure Eyebolt.
38. For Pro and Pro-XL: Pull the Dump Lever to raise the Cart and lift the Tube
Frame Handle at the rear to fully raise the Cart.
39. For Pro and Pro-XL: Install the left side Gas Spring as you did the right side
in step 2 of “Installing the Gas Springs”.
Note: There may be some Hardware left over that is not needed for your
application.
Tube Frame
Handle
Figure 43
Enclosure
Flap
Velcro Rear
Enclosure Sleeve
Figure 47
Outlet
Chute
Cable
Eyebolt
Hinge Pin
Figure 45
Hinge Holes
Cart
Eyebolt
Figure 44
Hole in Fabric
at the Front
Front
Top Tube Frame
Inside Enclosure
Knob
Figure 46
Hitch
Clip