DR Power Tow-Behind 9.59 Premier (September 2014 - Present) User Manual
Page 16
![background image](https://www.manualsdir.com/files/781818/content/doc016.png)
16
DR
®
LEAF and LAWN
Note: The Enclosure Fabric is intentionally a tight fit. It may be easier if you have a
helper for the next few steps.
19. Position the Tube Frame Handle onto the two upper corner Bolts at the rear
and loosely secure with Knobs (Figure 38).
20. From the inside, insert 5/16-18 X 2.5" C-Head Bolts through the two lower
Tube holes, Fabric holes, and Tube Frame Handle. Loosely install Knobs on
each lower Bolt (Figure 38).
Note: Rack the Enclosure (move it side to side) as necessary to help get the
lower Bolts all the way through the handle. If this is very difficult and the Links
are tight such that they are bowing significantly then re-position the Link Bolt as
described in the next step. Make sure the Links are locked before returning to
this step.
21. Slide the Retainer to unlock the Links. If the Links were very tight in the
Enclosure such that they bowed significantly, move the Link Bolt and
Locknut to the alternate hole in the Link (Figure 39). Keep the Links
unlocked for the next step.
22. Position the Hinge with flanges facing out onto the front corner Bolts
(Figure 40). Loosely install Knobs onto the bolts.
Note: Install the Hinge over the two Bolts on one side, add those Knobs, and
then pull the Hinge over the two Bolts on the other side.
23. Position the Front Retainer studs through the Hinge and loosely install
Knobs (Figure 40).
24. Inside the Enclosure, place one end of the Top Tube Frame onto the Bolt
between the Side Tube Frame and Knob (Figure 41). Loosely tighten the
Knob.
25. Position the other end against the Side Tube above the Bolt and push the
Top Tube down as far as possible by hand. Step on the Top Tube to push
down until the threads snap into the slot (Figure 42). Tighten the two Knobs
against the Top Tube Frame Bracket.
26. Slide the Retainer to lock the Links (Figure 42).
Top Tube Frame
(push down with
foot here)
Figure 42
Knob
Side Tube
Frame
Slot
Tube Frame
Handle
Figure 38
Rear
Upper Bolt
Knob
Lower Bolt
Knob
Rack
Top Tube
Frame
Figure 41
Knob
Hinge
Figure 40
Front
Knobs on
Retainer Studs
Corner
Bolts
Corner
Bolts
Figure 39
Retainer
Alternate
Link Hole
Link Bolt