DR Power Tow-Behind 9.59 Premier (September 2014 - Present) - Manual (Page 15)

CONTACT US AT www.DRpower.com 15
10. Lift up on the sides of the Enclosure so the Tube Frames go down inside the
Enclosure Fabric (Figure 31).
11. Inside the Collector, insert a 5/16-18 X 1.75" C-Head Bolt up through the Side
Frame Tube on both sides and place a Flat Washer into the Bolt threads (Figure
32).
12. Slide the Retainer of the folding Link Assembly away from the center hinge to
allow the Link Assembly to fold (Figure 33).
13. Place the Folding Link ends onto the Bolts and Washers (Figure 34).
14. Secure with Locknuts using a 1/2" Wrench. Only tighten the Locknuts snug
enough so the ends can still pivot without much resistance.
15. Straighten the Link Assembly (pushing down slightly at the same time) and
slide the Retainer toward the center till it overlaps to lock the Link in the straight
position (Figure 35).
Note: Make sure in the next steps that the shorter 1.75" C-Head Bolts go in the front
and the longer 2.5" go in the rear.
16. Align the two holes at the front corners of the Enclosure Fabric with the Side
Tube Frames and insert 5/16-18 X 1.75" C-Head Bolts through the Tubes (from
the inside) and through the Fabric Holes at both front corners (Figure 36).
17. Secure the C-Head Bolts in place with a Push Nut using a 7/16" Box End
Wrench or Deep Socket to push the Push Nuts fully onto the threads of the
Bolts at each front corner.
18. Align the two holes at the rear corners of the Fabric with the Side Tube Frames.
In the upper holes only as shown, insert a 5/16-18 X 2.5" C-Head Bolt through
the Tubes (from the inside) and through the Fabric (Figure 37). Secure with the
Push Nuts as in the previous step.
Center Hinge
Figure 33
Retainer
Figure 31
Front Rear
Retainer
Figure 35
5/16-18 X 1.75"
C-Head Bolts
Figure 36
Push Nut
Tube Frame
Holes in
Fabric
Front
Figure 34
Locknuts
1
2
Retainer
5/16-18 X 2.5"
C-Head Bolt
Figure 37
Push Nut
Tube Frame
Holes in
Fabric
Rear
5/16-18 X 1.75"
C-Head Bolt
Figure 32
Flat Washer
Tube Frame
Inside
Rear