DR Power Tow-Behind 9.59 Premier (September 2014 - Present) - Manual (Page 13)

CONTACT US AT www.DRpower.com 13
Figure 24
Front Rear
Right Side Enclosure
Retainer (Studs
Facing Up)
Square Angle
11. Using a Flat Head Screwdrive or 5/16" Wrench, loosen the Hose Bridge
Clamp, slide the hose onto the Housing neck, and tighten the Hose Bridge
Clamp very tightly (Figure 21).
Note: Make sure the Hose Bridge Clamp is past the Retaining Bumps on the
Housing.
12. Support the Hose with the Rubber Strap by hooking one end into the Support
Loop, going under the Hose and securing the other end onto the Support
Loop (Figure 22).
Collector Assembly (Use Enclosure Hardware Package, see Figure 7)
Tools Needed:

7/16" Deep Socket

7/16" Wrench
 1/2" Wrench

Hammer
Note: The Enclosure Fabric is intentionally a tight fit. Assembly is much easier when
you perform the following procedures in order.
1. Lay out the Enclosure Fabric onto a clean flat surface with the inside (black)
facing up and the front and rear oriented as shown (Figure 23).
2. Position the right side Enclosure Retainer next to the Enclosure with the
Studs facing up (Figure 24). Look closely at the stitching at both ends of the
Enclosure where the Retainer goes into the fabric. The Retainer shape at the
ends and stitching should match, square at front and angled at rear. If it
doesn’t match on this side, the Retainer goes on the other side.
Front
Sleeve
Figure 23
Rear Flaps
Inner Enclosure
(Black)
Inlet Hose
Figure 21
Clamp
Hose Bridge
Clamp
Retaining
Bump Clamp
Area
Hose
Figure 22
Rubber Strap
Hose Support