DR Power Tow-Behind 9.59 Premier (September 2014 - Present) - Manual (Page 14)

14 DR ® LEAF and LAWN
3. Insert the Retainer into the rear opening in the Fabric with the Studs tilted
slightly so they do not catch in the fabric holes (Figure 25).
4. Slide the Retainer all the way in and then twist to align the Studs into the
Fabric Holes (Figure 26).
5. Insert the Retainer on the opposite side.
6. Install the two Front Retainers into the Enclosure Fabric at the front corners
with the Studs pointing away from the holes and twist after fully installed to
get the Studs aligned into the holes (Figure 27).
7. Insert a 5/16-18 X 1.75" bolt into both Tube Frames as shown and secure
with a Push Nut (Figure 28). Use a 7/16" Box End Wrench or Deep Socket
to install the Push Nut fully onto the threads.
Note: The C-Head Bolt is designed to lay flat against the Tube curve. The threads
will not be long enough if the Head is installed in the wrong direction. See detail in
Figure 28.
8. Install a Knob about half way onto the Bolts of each Tube Frame (Figure 29).
9. Position the side Tube Frames, with the flanges facing up, onto the
Enclosure Retainer Studs (Figure 30). Install Locknuts a few threads onto
the Studs by hand so they are not tight. Five Locknuts on each side.
Tube
Frame
Figure 28
5/16-18 X 1.75"
C-Head Bolt
Push Nut
Wrong Right
Hole
Figure 25
Rear
Stud
Retainer
Angled Stitching
Stud
Figure 26
Hole
Tube
Frames
Figure 30
Flanges Facing up
1/4-20 Locknuts
Front
Rear
Flange
Knob
(inside enclosure)
Figure 29
Front Retainer
(studs facing down)
Figure 27
Holes on
other Side
Opening
Front