DR Power Tow-Behind 9.59 Premier (September 2014 - Present) - Manual (Page 12)

12 DR ® LEAF and LAWN
5. Lift the Cart Frame to align the rear hole in the Engine Unit with the hole in
the Frame and insert a 1/2" X 3.5" Clevis Pin and Hitch Clip (Clevis Pins and
Hitch Clips are provided in the Product Package) (Figure 16).
6. Chock the Wheels of the Cart to keep it from moving and have a helper pull
forward on the Outlet Chute so the Power Unit and Cart Frame front holes
are aligned (Figure 17).
Note: If you have a Floor Jack or similar you could jack under the Dump Lever to
align the Frames without a helper.
7. Insert the 2nd 1/2" X 3.5" Clevis Pin and Hitch Clip into the front holes of
the Engine Unit and Cart Frame (Figure 18).
8. Place the two 1/2-13 X 2.75" Bolts from underneath up through the two
vertical Holes and secure with 1/2-13 Locknuts using two 3/4" Wrenches.
Remove the Jack if one was used.
9. Unhitch the Cable Link from the Impeller Housing Bracket by turning the
hex portion of the link to open it up (Figure 19).
10. Slide the Hose Support into the Impeller Housing Bracket holes (Figure 20).
Cable Link
Figure 19
Impeller Housing
Bracket
Clevis Pin and
Hitch Clip (From
Product Package)
Figure 16
Trailer
Frame
Figure 17
Figure 18
2nd Clevis
Pin and
Hitch Clip
Bolts (Heads
on Bottom)
and Locknuts
Hose
Support
Figure 20
Impeller
Housing
Bracket